The main use for the KeyLab is as a controller for Arturia’s Analog Lab (one of my most used software). I ran "MIDI-OX and the keybord is out putting MIDI data. I then plugged in my Arturia KeyLap MK II and it IS NOT performing as it should even though it shows in the MIDI Port Setup as active, when you play the keys or move any of the controls nothing happens. I then plugged in my Korg nanoKONTROL Studio (in Cubase Mode) which performed as it should. I then plugged in my Arturia KeyLap MK II and again it performed as it should.Īfter closing Cubase Pro 11, I unplugged my two MIDI devices and opened Cubase Pro 12.Īs before I created a dummy project with 1 audio track and 1 MIDI track. I then plugged in my Korg nanoKONTROL Studio (in Cubase mode) which performed as it should. I then created a dummy project with 1 audio track and 1 MIDI track. I then rebooted my computer and opened Cubase Pro 11. It would not allow me to cancel or shut the process down so I had to CTRL+Alt+Del then Task Master, End Task with this as well. I then tried to open Cubase Pro 11 and it froze (or got stuck) at Load Mix Console > Loading Channel Stereo Out. As a precaution I also rebooted my computer. The only way out is a CTRL+Alt+Del then Task Master, End Task. In Cubase Pro 12 I had my Korg nanoKONTROL Studio plugged in, then while cubase is open, I plugged in my Arturia KeyLap MK II Cubase Pro 12 FROZE.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |